Please help me. PLEASE! port 43594 wont open! i will do anything. please

I HAVE PORTFORWARDED AND WENT TO PORTFORWARD.COM- i have foloed guides everything. yes i have no-ip- i have a WRT54G2 linksys router, i have portforwarded. ive download jdku11 and everything my main problem is. Port 43594 wont open, so i can log in and others cant! PLEASE HELP OR MESSAGE ME AT [email protected] i will do anything to make a server, ive been trying for a very long time. PLEASE HELP. - ive even bought the new router for 60$ just for a server...

PICTURES-

no-ip




my linksys portforwarded?




My firewall exceptions?


you can see how bad i want this-please help.

my no-ip options




hmm my jdk?




see i can log on but others cant!




moparscape status checker says port 43594 isnt open?



YOU CAN SEE HOW BAD I WANT THIS. PLEASE HELP!

also if you want me to add more just tell me....thank you

 

i may be able to help you add my msn

 

Check and see if your modem has a router page (mine does... and I had the same problem).

 

I have a guide on it but it seems like you are doing everything right, http://sythe.org/showthread.php?t=582630.

- Try disabling your firewall.
- Add my MSN if it still doesn't work i'll help you .

 

Run "ipconfig"

Look at what your local IP address is... I doubt it is 192.168.1.100

when you look at IP config, look at "IP Adress .......... 192.168.1.XXX"

The XXX is what you need to fill in where it says 100 on your port forward config page on the router...

 

The culprit is your IP you set it as. 192.168.1.xxx

As stated above.

Start>Run>CMD>Ipconfig. View the picture. Then change your router setting.


Also, its better to run 43593-43594. The router is picky.

 

Yeah, the only possible problem I see is the forwarding address. Start>run>cmd then type ipconfig. Enter, and that IPv4 or just IP address should be whats used. The last 3 numbers go over what you have on that "100".

 

Thank you sir, for repeating two posts in a row.