st1cky1cky
Active Member
- Joined
- Dec 15, 2008
- Sythe Gold
- 0
- Messages
- 195
How to make a tobacco pipe:
1. Get a big fat metal pen, take it apart and take the center peice:
At the right end of the middle of the pen is solder, it was already put together to see if it would work and it did so dont mind the solder.
Okay, so you now have a metal middle area of a pen, now you need two sockets [ you use sockets with some tool's out in the garage, im sure your parents have some ]
Now, take the sockets one that will fit perfect into the end as shown below you need one that starts out skinny and gets fat:
The example below the real socket is the socket you will need, insert the little end into the end of the pen it should fit snug, now hammer it down till it sits flush with the bigger end such as:
Now, leave the other end open as a choke [ choke is the area you put your finger over then you smoke your tobacco and release it, so you can inhale the tobacco smoke a lot harder.
Now add another socket on the top how? Get another one this will hold your tobacco now, it has to have a smaller end then get bigger like the one above, now drill a hole in top of the pen and put the other socket into the top small end first once its snug tap it in and put solder around it, or some other material that will seal it good and can hold up to heat.
Heres what is should look like:
now all you need is your tobacco and your in smoker's heaven, lol. Here is the finished project if you completed it right:
:noworry: guide by st1cky1cky, plus images =D
thanks for reading!
1. Get a big fat metal pen, take it apart and take the center peice:
At the right end of the middle of the pen is solder, it was already put together to see if it would work and it did so dont mind the solder.
Okay, so you now have a metal middle area of a pen, now you need two sockets [ you use sockets with some tool's out in the garage, im sure your parents have some ]
Now, take the sockets one that will fit perfect into the end as shown below you need one that starts out skinny and gets fat:
The example below the real socket is the socket you will need, insert the little end into the end of the pen it should fit snug, now hammer it down till it sits flush with the bigger end such as:
Now, leave the other end open as a choke [ choke is the area you put your finger over then you smoke your tobacco and release it, so you can inhale the tobacco smoke a lot harder.
Now add another socket on the top how? Get another one this will hold your tobacco now, it has to have a smaller end then get bigger like the one above, now drill a hole in top of the pen and put the other socket into the top small end first once its snug tap it in and put solder around it, or some other material that will seal it good and can hold up to heat.
Heres what is should look like:
now all you need is your tobacco and your in smoker's heaven, lol. Here is the finished project if you completed it right:
:noworry: guide by st1cky1cky, plus images =D
thanks for reading!
, only thing I would suggest is adding screens, (which I would do.) You just have to wrap the Socket in a screen at the bottom and solder it to the socket above where it will stick out of the pen, insert the socket and then solder it to the pen and voila no chunks of burning "green tobacco" going down your lungs 
). Wish me luck, but before I will quit, I will deffo try this out. This is really really interesting. Really cool guide.
