Garys Hood Autotyper.

[Deadmeat280]

I've been using this autotyper for years but I've never really bothered to ask;

If I have a notepad full of text that I want to be typed on each individual line in the typer opposed to all once. Is it possible to import that into the autotyper?

 

[S]

I've been using this autotyper for years but I've never really bothered to ask;

If I have a notepad full of text that I want to be typed on each individual line in the typer opposed to all once. Is it possible to import that into the autotyper?

No. Just set different hotkeys for each line of text?

I.e, line 1 (0), Line 2 (1) etc.

So you'd type, 0, 1, 2, 3 etc.

You'd have it set to you don't need to press enter once the hotkey is entered, it auto sends.

 

[Deadmeat280]

No. Just set different hotkeys for each line of text?

I.e, line 1 (0), Line 2 (1) etc.

So you'd type, 0, 1, 2, 3 etc.

You'd have it set to you don't need to press enter once the hotkey is entered, it auto sends.

And how do I go about doing that? I don't see any options on autotype to do any of the above.

 

[S]

And how do I go about doing that? I don't see any options on autotype to do any of the above.

Hmm, might not be possible then. Haven't used it since 2006/7.

 

[Deadmeat280]

Ah. I have several hundred auth codes to use on a server and you can only use them once every 10 seconds. I don't mind leaving autotyper on for an a few hours but I'd need to type them out line by line. No point of doing that because I could've just typed them into the server and relogged (to bypass 10 sec limit) and get it done in half the time.

 

[Jayzz]

Click on the File option on the auto typer, then select quick save. A notepad file named quicksave should appear on your desktop. Open it and copy over the auth codes.

Save and close the file, run your autotyper again and select the quick load option this time.

The auth codes you saved in the quicksave file will now appear in the autotyper.

 

[Naxious]

Click on the File option on the auto typer, then select quick save. A notepad file named quicksave should appear on your desktop. Open it and copy over the auth codes.

Save and close the file, run your autotyper again and select the quick load option this time.

The auth codes you saved in the quicksave file will now appear in the autotyper.

Worked for me, should for you too, thanks !

 

[Deadmeat280]

Click on the File option on the auto typer, then select quick save. A notepad file named quicksave should appear on your desktop. Open it and copy over the auth codes.

Save and close the file, run your autotyper again and select the quick load option this time.

The auth codes you saved in the quicksave file will now appear in the autotyper.

Thanks for this.