Computer help.

[Covey]

Hey guys, i recently replaced my Motherboard, CPU and PSU with the following:
mobo - Asus M2N SLI Deluxe
psu - generic 600W supply
cpu - AMD Athlon 5600

Since i've done this it, i turn my computer on and my screen gets 'no signal' how do i fix this?
(My screen is plugged into the first DVI point on my Graphics card, i can't plug it into the actual mobo because it only has an optics out and some other out i've never seen before (its green in colour)

Any ideas?

 

[fredecus]

First just make sure everything is seated properly. Normally something just isn't in right, also try changing the combination of your ram.

 

[Covey]

I just bought 2 new (second hand) 9600gt's off ebay. I'm still getting the no signal through the monitor.
Any got any ideas?
I should also state that all these parts were bought second hand (but i know they all are in good working condition).

 

[catsown]

Ooh, Did you try the 9600's in a second machine.. One alone, then two?

 

[kill dank]

I just bought 2 new (second hand) 9600gt's off ebay. I'm still getting the no signal through the monitor.
Any got any ideas?
I should also state that all these parts were bought second hand (but i know they all are in good working condition).

How do you know they're all in working condition? I mean, unless they've worked for you, you have no way to know.

 

[Covey]

Because of the chance of 3 graphics cards not working are a very low percentage, that low in fact i'm ruling it out.
It's something to do with the bios, i need to change the output in the bios but i can't get to it because i can't see it -.-

 

[kill dank]

Because of the chance of 3 graphics cards not working are a very low percentage, that low in fact i'm ruling it out.
It's something to do with the bios, i need to change the output in the bios but i can't get to it because i can't see it -.-

Well, make sure they all work.. It's not 3 that have to fail, it's one.

 

[Covey]

I think i'm just gonna put it into a computer shop this week sometime. I don't have enough time / resources to fuck about with it

 

[Aimless]

You need to use the d-sub/vga slot or a receiver for the optical S/PDIF out. Your board is highly susceptible to simply not working through DVI.