Anyone know how to make your own bowl from a nestea bottle ?

So I found this guide sometime ago how to make a killer bowl out of a small nestea bottle and I really liked the actual bowl, do any of you guys know how to make one ? Would be thankful

 

Are you talking about a bowl you can pack weed in? Please don't smoke out of anything plastic, spend the $5 at a smoke shop to pick one up.

Other than that, I don't follow you.

 

This is exactly what i was about to say. Also i really don't recommend use of aluminum.

 

Unless you're <16 there is no reason to smoke from "nigger-rigged" bowls anymore. Trust me, find a smoke shop and buy one of those penis looking bowls at the minimum, it's legit $5-10. When i was in high school my buddies and i split on a $60 bong and it lasted us for years. Getting a simple water piece will make things a hell of a lot easier, and it's really not that much in the long run.

 

There's books written with plenty of information on how to use every day items as bowls/rigs. I myself like creating smoking pieces as well but rarely keep them for long.

Painters mask: used tube and a cheap slider. You were able to breathe in and out without pushing the weed out of the slider. Was pretty cool but harsh

Iron lung: Bread bag and 2 liter bottle.. Cut the bottle in half and tape the bag around the cut part. Then poke a hole in the cap and melt a glass slider into the cap. You push the bag into the bottle and light the weed in the slider while pulling the bag out. Pulls the smoke in and prepare for a really really harsh hit. Seriously harsh lol

Home made vape: Take a regular light bulb and break off the top part the screws in. Pour salt into the bulb to remove the filament around the glass. You then take a coke bottle and cut it 70%. Cut all around the bottle and use tape so you can form the bottle around the bulb. You then poke a hole into the cap and use a pen cap so you can pull in the smoke. also poke another hole in cap as a carb. when done properly you can unscrew the cape and drop the weed in. You then use a lighter and heat up the weed by placing the flame against the light bulb. The heat release the thc without burning the weed and thus your own home made vape. I have videos on my old phone.

ive also made my own water bong gas masks with acrylic bong and tube.

The easiest and most efficient in my opinion is the gravity bong. I used a 5 gallon bucket and Hawaiian Punch bottle. cute in half and use same glass slider and cap technique. light the weed while pulling the bottle up and unscrew the cap and rip it till its gone. Ground shattering hits be careful

Just want to point out that though these will work there not the most efficient. These were just my friends and me bored making random smoking tools. Just buy a glass bowl or a nice glass on glass bong and do it right. If you really want to be efficient i suggest dabs and a rig set up or vape pen.

 

Heating of polymers in plastic can reverse the process releasing monomers into the air. While polymers are really safe for food storage their individual monomers are often highly carcinogenic and toxic. I'd strongly recommend heeding to the advice of others above and avoiding plastics for make shift bongs.

Source: My several research papers on polymer technology.

 

Like everyone else is saying i wouldn't suggest using it for that if that's what you are going to use it for you can glass ones online smaller ones for 3-10$ which isnt bad if you break can always buy a new one but plastic isnt good for you inhaling

 

Okay, thank you guys ! Never realized that this is unhealthy . Gunna head to the store later today

 

Glad to hear that

 

All the chemicals in the plastic is discusting that you put into your body, dont.

 

yo i got you man right here

 

Pretty much covers it