AnthonyL1991
Apprentice
The Four-in-Hand Knot
Step One
Start with the large end on your tie on right side and extend it about a 10-12 inches below the small end of your tie.
Step Two
Take the large end of your tie and place it over the small end of you tie.
Step Two
Take the large end of your tie and place it over the small end of you tie.
Step Three
Take the large end of your tie and place it underneath the small end of the tie.
Step Four
Take the large end of your tie and place it over the small end of your tie, just like in step two.
Step Five
Take the large end of your tie and place it through the back of the loop of your tie.
Step Five
Take the large end of your tie and place it through the back of the loop of your tie.
Step Six
Take the front of the knot and hold it loose with your index finger, then pass the wide end downward through the loop that you made in step four.
Step Seven
Remove your finger from the knot and firmly tighten the knot.
Step Eight
Hold the small end of your tie and gently slide the knot up to the collar.
The Windsor Knot
Step One
Start with the large end on your tie and extend it very low leaving the small end very short.
Step Two
Take the large end of your tie and place it over the small end of your tie.
Step Three
Take the large end of your tie up through the middle of the loop and to the left.
Step Four
Take the large end of your tie behind the small end of your tie.
Step Five
Take the large end of your tie and place it through the middle of the loop.
Step Six
Take the large end of your tie and bring it around the front.
Step Seven
Take the large end of your tie and bring it through the back of the loop.
Step Eight
Take the front of the knot and hold it loose with your index finger, now pass the large end downward through the loop in front.
Step Nine
Remove your finger from the knot and tighten it
Step Ten
Hold the small end of your tie and gently slide the knot up to the collar.
The Shell Knot
Step One
Start with the inside of your tie facing outward and the large end on your tie extending about a 10-12 inches below the small end of your tie.
Step Two
Take the large end of your tie under the small end of your tie.
Step Three
Take the large end of your tie, place it over the small, and through the loop.
Step Four
Take the large end of your tie through the back of the loop.
Step Five
Take the front of the knot loose and hold it with your index finger, then pass the large end down through the loop in front.
Step Six
Remove your finger and tighten the knot.
Step Seven
Take the small end of your tie and slide the knot gently upward to the collar.
